![]() (*The 5.25” legacy products use a cartridge tape as the storage media and are themselves floppy drive emulators for the Shugart™ floppy drives). USB Port - Used for microcode load and real time diagnostics, eng setup.įloppy Interface available with SLIM-26, FLAT-34, 5.25” & 8 Shugart edge connector interfaces with full height and half height frames. Connector matches floppy drive emulated.ĭata Connection - Data cable connection is normally made to a 34 pin standard floppy edge connector at the rear of the FLOPPYFlash circuit boardĭata Transfer Rate - 125kb/s to 500kb/s (Note: Data rate is linked to the coding method selected) Power Requirement - 5 Volts only 0.8 Watts (Typical), with CF fitted. Solid State Disks FLASH2GUI Youtube Channel hereĭimensions - 3.5” Floppy form factor – 102mm (4”) wide x 147mm (5.75”) long x 25mm (1”) high.Ĭompact Flash Connection - Standard 3M header, with ejector, for Type 1 and 2 cards. This file can then be resent to the FLOPPYFlash drive as new data file. Allowing the unpacking, editing, and repacking of the imaged file. The embedded Flash2GUI Image Editor allows image files (.img) to be sent from the FLOPPYFlash drive to a local onsite PC or server. This offers a demonstration of how the proprietary FLASH2GUI software used alongside the Network FLOPPYFlash drive can offer a a bit for bit image copy of the data allowing backup & restore network capability, alternative drive select options, and also capacity and blocks select features. Please click the link below to see the Solid State Disks FLASH2GUI Youtube channel. ![]() The product’s configurable firmware allows a perfect host match, eliminating the need for any host hardware or software changes. The FLOPPYFlash product allows OEMs and service providers to have a quick, cost efficient solution to support their legacy system. ![]() Similarly, the emulated track configuration is programmable. The FLOPPYFlash is available with SLIM-26, FLAT-34, 5.25” & 8 Shugart edge connector interfaces with full height and half height frames.įurther the FLOPPYFlash drive will replace 3.5”, 5.25” or 8” drives, both soft and hard sectored and may be set to operate at various data rates with the matching data encoding schemes, FM, MFM, or MMFM. The FLOPPYFlash is an industrial/OEM grade programmable hardware emulator that uses standard industrial Compact Flash card technology to provide a solid state, drop-in replacement for obsolete electromechanical floppy disk drives. Solid State Disks Ltd, design and manufacture the Solid State FLOPPYFlash™ drive More details on FLASH2GUI backup & restore software click here Primary data storage is always written to the CF card. The FLOPPYFlash is not suitable for home/hobbyist usage.įLASH2GUI - Optional ethernet support for centralised backup & restore capability available removing the need to rotate media. The FLOPPYFlash is designed as a drop in replacement to the industrial/ OEM & maintenance provider space. The drive will replace both soft and hard sectored and may be set to operate at various data rates with the matching data encoding schemes, FM, MFM, or MMFM. The FLOPPYFlash is available with SLIM-26, FLAT-34, 5.25” & 8 Shugart edge connector interfaces with full height and half height frames FLOPPYFlash Emulator to replace legacy floppy disk drives, using removable Compact Flash. No additional software or register changes are required to the legacy host. Network backup and restore capability supported through on board RJ45 ethernet port.
0 Comments
Leave a Reply. |